Hello All,
I have old Clarke Tech ET9000 box, installed openpli image from 10/2015 and a few automatic updates.
Everything was OK until yesterday when I installed picons from Plugins, the installation to flash memory failed due to not enough space therefore I repeated it to HDD. Later I noticed that recording caused the crash of box, therefore I decided to reinstall box with the latest openpli image. The installation finished without any issue, but when I tried download CCCAM 2.3.0. then I got message :
perhaps you need to run 'opkg update'.
According hint from internet I tried commands :
opkg update
opkg upgrade
reboot
but opkg upgrade command failed with same error.
then I tried :
- install old image from 10/2015 which was running fine before, now same error
- factory reset, same error
- disconnect HDD, same error
I would appreciate any help
Thank you
Pavel