Hi all,
I am new to the OpenPli builds for the VU+ DUO2. Previously I had been using OpenATV and occasionally would try out VIX/OpenVIX, but due to stability issues of late with those versions I decided to give OpenPli a try. So far so good and I am quite impressed by this version. I am however finding it hard to locate some options that were in the other builds that I can't find in OpenPli, so I am hoping someone can tell me where they are.
1. When the unit is recording, with OpenATV I could select deep standby and it would enter standby and then go into deep standby when the recording(s) finished. When I do this with OpenPli it stops all recordings and goes into deep standby. Is there an option to make it enter deep standby after the recordings have completed?
2. OpenATV also had an option to configure what the unit would do when power was restored after a power outage. You could select deep standby, standby or on. I can't seem to locate a simular setting with OpenPli.
That's it really. Apart from the above, I am really impressed with OpenPli and do not see any need to go back to the other versions.
Regards,
Craig