Finally got to run my usb dvb-t but when I connect other usb stick ( for picons and epg ) and reboot, the usb dvb-t stops working.
When I connect the usb dvb-t only with dsmeg I get:
“dmesg | grep usb
usbcore: registered new interface driver zd1201
__clk_enable: usb [1]
usbcore: registered new interface driver usb-storage
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
usb 1-1: new high-speed USB device number 2 using ehci-brcm
usb 1-1: dvb_usb_v2: found a 'AverMedia AVerTV Volar Black HD (A850)' in cold state
usbcore: registered new interface driver dvb_usb_af9015
usb 1-1: dvb_usb_v2: downloading firmware from file 'dvb-usb-af9015.fw'
usb 1-1: dvb_usb_v2: found a 'AverMedia AVerTV Volar Black HD (A850)' in warm state
usb 1-1: dvb_usb_v2: will pass the complete MPEG2 transport stream to the software demuxer
usb 1-1: DVB: registering adapter 1 frontend 0 (Afatech AF9013)...
usb 1-1: dvb_usb_v2: 'AverMedia AVerTV Volar Black HD (A850)' successfully initialized and connected”
but when I connect the usb stick and restart, the usb dvb-t stops working and this is what I get:
“dmesg | grep usb
__clk_enable: usb [1]
usbcore: registered new interface driver usb-storage
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
usb 1-2: new high-speed USB device number 2 using ehci-brcm
scsi2 : usb-storage 1-2:1.0
usb 1-1: new high-speed USB device number 3 using ehci-brcm
usb 1-1: dvb_usb_af9015: command failed=170
usb 1-1: dvb_usb_v2: 'AverMedia AVerTV Volar Black HD (A850)' error while loading driver (-5)
usb 1-1: dvb_usb_v2: 'AverMedia AVerTV Volar Black HD (A850)' successfully deinitialized and disconnected
usbcore: registered new interface driver dvb_usb_af9015”
any help?
thx