i have been using openpli based images for a long time on my et9000 with 2x dvb-s2 tuner setup.
both tuners set the same as i am using a dual monoblock with diseqc
since i started to use openpli 4.0 based images (from here or from hdfreaks) i noticed that after a recording starts when i watch a channel adter a while i get image hickups or complete image stops.
i thought it was performance related but i tried cleaning up memory, flushing cache, no high cpu usage in the box and it is always the same.
i am using oscam as newcamd client and there are no problems until the recording starts.
i tried to switch the preferred tuner from A to B but it behaves the same.
tried to change the "set voltage and 22 KHz" tuner setting with no change
tried to uninstall all plugins so i am sure there is nothing interferring with the recording. always the same
when recording also the zapping is extremely slow. normally it zaps between 1-2 seconds while on recording it zaps over 5 seconds.
1. is there anything i can try to narrow down this issue?
2. can i use some older tuner drivers with openpli4? where do i get them?
3. is there any known stable openpli 4.0 based image which is known to work with 2 tuners on et9000?
4. anybody seen an et9000 with simillar issues?