Hi,
Since reflashing to a new image that uses the latest drivers I have had a new problem.
I use a motor with diseqc 1.2 connected to my VU+ duo. I use stored motor positions rather than USALS as I can get much finer reception.
The problem, After flashing, I sent my channel list through to the box, found the sats and stored the postion. For half a day it seems to work fine, but then i start getting a problem where it wont zap to another sat. If I switch of box, it seems to go back to normal for a while, but less time than before and the problem repeats until nothing works.
I have flashed with PLI, VIX, VTX and always get the same problem. I have the cables on the tuners to use different tuner and I have limited the plugins to see if a plug in is causing it, all to no avail. The box has been working perfectly until I flashed with new image.
anyone else having problems with stored motor positions or know what might be up?
Regards
Since reflashing to a new image that uses the latest drivers I have had a new problem.
I use a motor with diseqc 1.2 connected to my VU+ duo. I use stored motor positions rather than USALS as I can get much finer reception.
The problem, After flashing, I sent my channel list through to the box, found the sats and stored the postion. For half a day it seems to work fine, but then i start getting a problem where it wont zap to another sat. If I switch of box, it seems to go back to normal for a while, but less time than before and the problem repeats until nothing works.
I have flashed with PLI, VIX, VTX and always get the same problem. I have the cables on the tuners to use different tuner and I have limited the plugins to see if a plug in is causing it, all to no avail. The box has been working perfectly until I flashed with new image.
anyone else having problems with stored motor positions or know what might be up?
Regards